Mesh Cable Tray Clip Installation Method

Mesh cable tray clips are installed by snapping or securing the clip onto the tray and fastening it to the support structure, ensuring proper alignment and load support.Step-by-Step Installation1. Prepare the Tray and Clips Before installation, ensure the mesh cable tray is cut to the required length using a power cutter or bolt cutters if necessary, and select the appropriate clip type for your tray model (e.g., FASLOCK or PRECLICK systems for Cablofil trays) . 2. Position the Clips Place the clips at the designated support points along the tray. Standard practice is to install clips at each end of the tray and at intervals according to the tray manufacturer's load specifications, typically every 3 feet or as required for heavier cable loads . 3. Attach the Clips to the Tray Snap the clip onto the mesh tray by aligning it with the tray wires and pressing it into place. Some systems may require a light tap with a screwdriver or mallet to secure the clip fully . Ensure the clip grips the tray firmly without deforming the mesh. 4. Secure the Tray to the Support Structure Once the clips are attached, fasten them to the wall, ceiling, or other support brackets using screws, bolts, or threaded rods as specified by the manufacturer. For Cablofil FAS systems, connections can often be made without additional hardware, while other systems may require nuts and bolts . 5. Check Alignment and Stability After all clips are installed, verify that the tray is level and properly supported. Adjust clip positions if necessary to prevent sagging or uneven load distribution. Ensure that the tray is not used as a walkway and is only supporting cables . 6. Install Cables Feed cables into the tray, ensuring they are evenly distributed and do not exceed the tray's load capacity. Use additional clips or cable ties if needed to secure cables within the tray .Tips and Best PracticesUse corrosion-resistant clips for outdoor or humid environments.Avoid over-tightening clips to prevent damage to the mesh.Follow manufacturer guidelines for maximum load and spacing.For bends or branches, use the tray's flexible mesh design and attach clips at each directional change . By following these steps, mesh cable tray clips can be installed securely, providing a durable and flexible cable management system suitable for industrial or commercial applications .