To start clean, first reset the unit: Hold the reset pin (while the unit is powered on) for ~10 seconds. When the status LED blinks rapidly, release the button. The MyRackspace Portal now has a new reboot option for network devices. You can also use this option when your device experiences security. Issue My UPS Network Management Card or Network Management Card-enabled product is reporting one or more of the following alarms: “ System: Warmstart, “ “ System: Coldstart, “ “ System: Network Interface restarted, “ “ System: Network Interface Coldstarted. Network Management Card 2 (NMC2) -. Does pressing the pinhole reset button on a Metered or Switched Rack PDU or Rack ATS cause the outlets to reboot or disrupt power in any way? Environment Many users ask if rebooting their network management card affects outlet status or power output of their device. The restart sequence and effects are as follows: If the rack is in the Running power state, the. However, to safeguard system integrity, it is recommended to use the Mission Control to perform the reboot sequence. The cold rack reboot sequence should be executed for the following use cases: After the initial software installation. In some cases it's useful to do a full factory reset of the MixRack. This is done by accessing a set of 4 DIP switches, inside the I/O port on the C Class, or inside Power 2 on the S Class (see photos) After READY LED illuminates, turn off MixRack and move Switch 1 back to OFF position.
