-
Causes of Static Electricity in Distribution Boxes
Static electricity is typically generated through triboelectric charging, which occurs when two dissimilar materials contact and separate, causing electron transfer. In manufacturing, this happens with plastic films, paper webs, textiles, and conveyors. The charge remains until it can move away as an electric current or by electrical discharge. These discharges may be harmless or probably dangerous, relying on the environment and. etc. Please see the OSH Answer How to Work Safely with Hazardous Products Using the "Flame" Pictogram for general information about working with flamma nces, like clothes tumbling in your dryer. Understanding how static electricity is generated—and how to neutralize it—is key to maintaining product. The impact of electrostatic charges on powder flowability is usually not well known but it can cause bad flowability, segregation, powder build-up that can be troublesome for a company, especially when filling powders.
[PDF Version]
-
Explosion-proof distribution box static grounding wire
Grounding of Metal Cabinets: Metal explosion-proof distribution boxes must be reliably grounded, with the grounding wire connected to the cabinet's outer shell. For three-phase systems without a neutral wire, the grounding wire should have a cross-sectional area of at least 4mm². In factories, construction sites, and even commercial buildings, this question pops up all the time. Requirements for Explosion-Proof Piping Installation The installation of explosion-proof pipelines. Electrical sparks or static electricity can ignite the combustible gasses, vapors, or dust that are common in these settings. Proper grounding reduces the likelihood of ignition by maintaining all conductive parts at the same potential and minimizing the buildup and discharge of static energy. Getting this right demands more than following a checklist.
[PDF Version]
-
Fiber Optic Target Flow Meter Sensor
We propose a flow meter that, unlike turbine or pressure-based sensors, is not flow intrusive, requires zero maintenance, has low risk of clogging, and is compatible with harsh conditions. Using optical fiber sensing, we monitor the temperature distribution along a fluid. In this paper we review the main features of SMSs as temperature sensors and we present a potential biomedical application in an all-fiber flowmeter based on the hot-wire principle: a fiber-coupled laser source at 980 nm is used as a controllable heating source of the SMS sensor that, when immersed. Monitoring fluid flow rates is imperative for a variety of industries including biomedical engineering, chemical engineering, the food industry, and the oil and gas industries. Quickly and easily recognize the sensor status by simply looking at the fiber head. Differential measurements of temperature and pressure are achieved using two FBGs.
[PDF Version]